Ideas Floating Glass TV Stand – Before the hardware assembly glass TV stand, the best position to find mount your television. Once you’ve decided the overall positioning of the wall mount installation, cut from a piece of cardboard or wrapping paper in proportion to the size of the flat panel television. Then the placement by taping approach the piece of cardboard or wrapping paper on the wall where the TV will be placed and mark it with a pencil.
For placing TV with floating glass TV stand, Remove the position of the television and put the TV on his face. Locate the four mounting holes on the back of the TV and remove the bolts. Then remove mounting the mounting arms or wall mounting plate from the packaging. Attach mounting arms; align the arms vertical and parallel to each other through the mounting holes on the back of the television. If you are using a mounting plate, simply line up the holes with the mounting holes on the television. Attach the mounting plate with screws and washers to your wall mount.
Next steps placing TV with floating glass TV stand locate the studs closest to the desired position and mark them. Remove the wall bracket from the package. Line up the wall mount to the studs in the middle of the marked position you defined earlier. Using mount a level, line up the wall and mark the position of where he will go nuts. Drill holes in the stud about 1 “deep, drill bit size is dependent on the size of the bolts with supplied secure the wall. Screw the wall holder to the wall with screws and washers, but does not fully tightening the bolts. Adjust the position of the wall mount left or right to center it to your desired position. When finished, tighten the bolts of the rest of the way. Lift the TV and connect to mount it on the wall. At this point you can adjust the horizontal position to center it perfectly. Once the desired position is obtained, tighten down the screws that mount the mounting arms or the plate to the wall.